We are open 7 days a week.  9am to 5pm Monday to Friday and 10am until 3pm weekends.  (Bank Holidays vary)

Covid restrictions remain in our shop to protect you and our staff, thank you.

Welcome to our new website, its far from finished but we are working hard, please bear with us.

Kinshi High Tech Sieve III

The High Tech Kinshi Sieve III is a Pump Fed pre-filter to filter waste solids from the water via a bottom drain or through a skimmer. This technique incorporates a sieve-bend. A sieve-bend consists of hundreds of sharp stainless steel profile wires with very small slot openings where the water can go through but the solids stay on the sieve bend.

In practice it works as follows: The water enters the High Tech Kinshi Sieve III via a water pump as this model is pump fed only and passes through the “auto-adjustable” dam and will go upwards and fall over the weir on to the Stainless Steel sieve-bend.

The water goes through the sieve bend and the waste solids will slowly go down to the waste area. At the waste outlet of the filter is a 2 inch male thread connection with end cap for attaching a 2 inch slide/Ball valve to easily wash away the waste with water.

The pump will be connected to the 110 mm Polypropylene inlet via a Rubber Boot .

An extra advantage of High Tech Kinshi Sieve III pre-filter is that the water will be provided with extra oxygen, when it goes through the slots. Plus the mechanical waste is removed from the water itself, also its important to make sure the High Tech Kinshi Sieves are on an equal, level, ground.

Between the bottom drain and the High Tech Kinshi Sieves or a skimmer and the High Tech Kinshi Sieves we strongly advise you to use a slide valve or ball Valve to separate the High Tech Kinshi Sieves from the pond when necessary.

The inlets of the High Tech Kinshi Sieves are made of 110 mm Polypropylene pipe so you can use one of our rubber boots to join the two together. Since the High Tech Kinshi Sieves are made of Polypropylene you cannot make any glue connections. The High Tech Kinshi Sieve range have 1 inlet up to 3 inlets all 110 mm depending on which model and flow you require.

The High Tech Kinshi Sieve has a floating system to prevent the water in the area under the sieve from rising above the level of the sieve for low speed pumps and also to prevent the water from going too low to be primed for high speed pumps.

To remove the waste that is on the surface of the High Tech Kinshi Sieve is very easy by opening the waste outlet and to rinse the waste away with a normal hosepipe. Another method to have water run over the screen is pushing down the adjustable dam, which will flood the screen with water. When the adjustable dam is in a low position already because of the pump speed you can pull up the dam for a short while and push it back downwards again.

To remove the waste that has gone into the profile wires of the High Tech Kinshi Sieve (only when necessary) you will need a hosepipe with a powerful spray nozzle or a high-pressure machine. For this way of cleaning you have to place the sieve in an upright position or take the sieve out of the unit. After a certain period of time the sieve can get “fat” and this will make it more difficult for the water to go through. You can clean the sieve with i.e. alcohol. Note: when you use the sieve for the very first time the surface of the sieve can also be covered with a very thin film. Make sure you clean the sieve very thorough with alcohol before using it.

High Tech Kinshi Sieve III Technical Specifications:

  • Pump Fed Prefilter
  • Pump capacity: 20 000 liters / hour
  • Dimensions: 50 cm L x 47 cm W x 60 cm H
  • Water supply: 1 x 110 mm
  • Outlet: 1 x 63 mm
  • Drain Plug: 1.5 inch (50 mm) with ball valve
  • Stainless Steel 316 Screen 445 x 400 mm
  • 300 micron Stainless Steel screen
  • Standard lid on the screen
  • Part No. 0088203
  • Material: Polypropylene
  • Colour: Sahara

The perfect solution for pump capacities up to ±20m³/h. (20000 lph) The most ideal pre-filter! Create a compact filter system by combining the High Tech Kinshi Sieve III with other filters.

Please Note: The High Tech Kinshi Sieve III is Pump Fed only and is not suitable for Gravity fed systems.